Rebar Bender - Single Phase

Single phase, 115V operation

Capacity: #6 - 3/4" - 20MM
2 x #5 (15 mm), 3 x #4 (12 mm)
c/w foot pedal control, rollers, split pin
stirrup assembly. Simple slide block mechanism
allows the operator to quickly and accurately adjust and pre-set up to 2 angles.
Adjustable from 0 - 180 degrees, maximum single CCW bending direction
Machine weight approx. 165 lbs

Show Less

Single phase, 115V operation

Capacity: #8 - 1" - 25MM
c/w dual foot pedal controls, 2 drive rollers
with bearings for rotation, and 3 center rollers 65, 95, & 125 mm diameter (2.5", 3.75" & 5" approx)
Split pin stirrup assembly with 2 bending radii.
Bars are not dragged through machine, but held
firmly during bending. Adjustable hold back device.
Simple slide block mechanism allows the
operator to quickly and accurately adjust and
pre-set up to 2 angles.
Adjustable from 0 - 180 degrees, maximum
single CCW bending direction
Bends 1 x #8, 2 x #6, 2 x #5, 3 x #4, 4 x #3
Machine weight approx. 325 lbs

Show Less

Capacity: #8 - 1" - 25M High Tensile Grade 60 Rebar
Single Phase Operation, 115 volts, 60 Hz

Includes TYB-HD35 Table Bender with RC-25 Cutter mounted on common steel stand.
Each tool can be used independently and removed from stand.
(Requires 2 x 115 volt electrical connections)

Bending & Cutting: 
TYB series bender model HD26 or HD35 (as above) 
System Weight (bender, stand, shear): approx. 435 lbs

Show Less

Economical electric spiral rebar bender for job sites and precast facilities

Features:

• Three Adjustable Bend Rollers
• Special center roller
• Speed approximately 30 RPM
• Adjustable plate for spiral pitch-height
• 6" minimum diameter to unlimited maximum

Electric Power/Requirements:

• 2HP Motor
• 230v.
• Single Phase
• 12 amps

Show Less